» Products » Perforation Tester

Perforation Tester

PST - 2001

Perforation means testing the elongation or strength of the material. Hence, the Perforation method of testing is used to measure the elongation and tensile strength of thermoplastic films. The main motive to perform this test is to measure the force which is required to separate the film from the place of perforation. This is carried out with the help of a testing machine known as “Perforation Tester”. During this test, the film is perforated using a flat point and a cylindrical needle. Apart from the perforation force, a noticeable elongation 1 is read from the curve known as “stress-strain” curve. This result is then compared with the convention test of tensile testing. The perforation method requires few samples to perform the test.



1 Star2 Stars3 Stars4 Stars5 Stars ( 5.00 out of 5)
Loading...Loading...

Rate this Product



    • Load Cell Capacity: 50Kgf
    • Display: LED (Digital) 7 segment
    • Accuracy: ± 2% at full load (with master load).
    • Least Count/Resolution: 10 gm
    • Power: 220V AC, 5 Amp., Single phase, 50 Hz
    • Test Speed: 300 mm/min± 5%
    • Test Sample Grip Size: 140 mm ± 5 mm (width)

    • Microprocessor based display for accurate test results
    • Works on Constant Rate of Elongation (CRE) Principle
    • Display for Perforation strength of test specimen
    • Highly accurate test results under Tensile force
    • Strong gripping clamps to perform test at 180 degree.
    • Bright LED display
    • Inbuilt calibration facility
    • Feather touch controls






Write a Review for Perforation Tester


eight × = 32